1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

tascam dm 4800, anybody use it before?

Discussion in 'Recording' started by loh90, Mar 3, 2008.

  1. loh90

    loh90 Guest

    we are planning to open a new studio (with $15,000 worth of equipment and furnishing). The Tascam DM 4800 looks like the best bet. We want to use it as a front end that we will digital out into a M-Audio 2626 into Pro Tools. We also want to use it as a mixing control surface for Pro Tools. Anybody use this before and have any experiences on its usability, quality, and A/D converters?
  2. therecordingart

    therecordingart Well-Known Member

    Jul 28, 2004
    The studio I'm an independent at just installed one. So far it's pretty nice. Sounds good and the built in fx are useable. Not fantastic but worth the few $k. A utility piece of gear more than a money piece of gear.

    The biggest downsides is that it has somewhat of a learning curve with the digital routing, and the way it is packaged by Tascam almost guarantees a damaged unit. We had two show up at the studio with the same damage caused by insufficient packaging. Make sure you inspect it thoroughly....especially the rear panel.
  3. lytes

    lytes Guest

    same here... we're about to install one, I've never used it, but was wondering the limitations with protools.

Share This Page