1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Tascam FW1884

Discussion in 'Recording' started by Farbion, Nov 16, 2005.

  1. Farbion

    Farbion Guest

    :roll: :roll: :x how do I use the fw 1884 just as a control surface to get only one recording output when using logic? I've tried reinstalling the firmware but still get a dual output when recording. PLEASE HELP
     
  2. Eriksmusicproduction

    Eriksmusicproduction Active Member

    You mean that you hear both the computer monitor'd signal and the direct monitor from the 1884?

    Not a logic user but you may try changing the devices to only direct monitor or computer monitor. Not sure what logic calls it but it must have some kind of a section for devices and monitoring?
     
  3. Farbion

    Farbion Guest

    I've tried to find the controls that you have mentioned but am not having any luck. Do you have a 1884? :wink:
     
  4. Eriksmusicproduction

    Eriksmusicproduction Active Member

    Yes I have a 1884, but I run it on cubase so I'm not really sure how to change the settings in logic, must have something in the manual though.

    You can also press the "mon mix" button on the fw1884 which will make it act like a 8/2 analog mixer but there should be a way to change it to direct monitor in logic as well.

    Hope this helps, maybe someone familliar in logic can chime in.
     

Share This Page