1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Tascam us1800 monitor latency error

Discussion in 'Recording' started by Mojavegary, Feb 18, 2014.

  1. Mojavegary

    Mojavegary Active Member

    I am using a Tascam US1800 interface with my PC running windows 7 home premium and pro tools 11.
    Periodically when I start pro tools I get a error message from PT that my audio interface is set to a non supported latency setting. Opening the 1800 control panel reveals that the 1800 has reset the latency to normal. I then set it back to low latency, restart PT and all is good until the next time the 1800 decides to reset the latency to what I assume is the default. Has anyone else encountered this issue and if so, is there a solution? Thanks.
     
  2. DonnyThompson

    DonnyThompson Distinguished Member

    You might want to look into ASIO4all. Everyone I've known with a Tascam I/O ends up with issues similar to yours, and installing this driver seems to help.

    ASIO4ALL - Universal ASIO Driver
     
  3. Mojavegary

    Mojavegary Active Member

    Thank you

    Thank you for your reply. I will check into that driver.
     

Share This Page