1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

TDM Transmission error in Digitest

Discussion in 'Recording' started by rubberlugs, May 30, 2007.

  1. rubberlugs

    rubberlugs Guest

    Anyone familiar with TDM Transmission error in Digitest, No TDM clock found? Its a d24/mix combo. Mix farm in slot 2, (slot 1 graphic card). D24 slot 3 and farm card in slot 4. Everything was working over a period of 2 years with this set up. Then it sat for 6 months with no use. Pulled it out earlier in the week, ran digitest and got error TDM clock not detected on all cards. I don't have an interface to test with this issue so don't know if this means it won't work completely or what.


    Also, once I've posted a topic, where is it I find it again in my profile instead of trawling through all posts tio find it again.

    Cheers in advance.
     
  2. TVPostSound

    TVPostSound Guest

    You really need an interface to run Digitest.
    If the error still shows up with an interface, thn reseat all the cards, and the TDM cable (The one that connects the 3 cards)
     
  3. rubberlugs

    rubberlugs Guest

    I wasn't sure on that. So with three cards do the NEED to be connected together with a healthy ribbon cable and does digitest NEED at least 1 interface connected?

    Cheers, I'll need to try and get my hands on a unit.
     
  4. hueseph

    hueseph Well-Known Member

    Hi,

    Just browsing here. I know nothing about PT TDM but as far as finding your post: when you make a post there is a little check box at the bottom that says "email me when someone replies to this post" or something to that effect. You can also make this the default by editing your profile.

    Carry on.
     

Share This Page