1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

The Motu 828mk11 multi ch, which driver

Discussion in 'Recording' started by bwmac, Sep 14, 2007.

  1. bwmac

    bwmac Active Member

    Mar 15, 2007
    In the manual for the 828 it says
    "If your host audio software does not support WDM drivers,
    enable wave driver compatibility in the motu audio WDM driver
    so that all of the 828mk11's inputs and outputs show up in your software."

    What it means is to enable the (MME) drivers which are less efficiant and
    it even states it.

    I use sonar-6 and I am wondering why all of my I/O dont show up.
    In my drop down menu for the track input it shows everything in pairs.

    I have compaired both asio and WDM drivers and they display the I/0 the same.

    I am only looking for anyone with the 828 that may have come across
    this inconveience and what they did oor where they found the driver to rectify this little problem.

    I haven't tried the asio drivers in cubase yet to see if that host displays the I/0 differently, but i will later, just thought of it, LOL

    OK,... WHat Say You[/b]

Share This Page