1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

trivial question: how to add effect to monitor?

Discussion in 'Recording' started by pob579, Dec 28, 2006.

  1. pob579

    pob579 Active Member

    Hi,
    I use Behringer UB1204 mixer.
    I cannot figure out how to get reverb in monitor.
    I tried both: connected effect to aux 1 and took signal for monitor from
    aux 2 and vice versa. No effect in monitor.
    What is the trick? If possible detailed instruction for this mixer.
    I use Yamaha stereo effect.

    Thanks,
    Michael.
     
  2. pob579

    pob579 Active Member

    Just found an exellent explanation for my question.

    It's here:

    http://www.studio-systems.com/audiofeatures/JulyAug2001/Mackie/79.htm
     

Share This Page