Hi I am kitting out a new studio is Aus and was wondering if anyone has any amazing advice about IO I am thinking about getting HD I/O 16x16 Analog The ideal choice for music productions—get the maximum complement of analog inputs and outputs (can be customized by replacing a card, but not expanded). High-quality analog I/O: 16 analog inputs (using DB25) 16 analog outputs (using DB25) Additional digital I/O: 2 channels of AES/EBU I/O (supports 192 kHz single-wire) 2 channels of S/PDIF I/O 8 channels of ADAT I/O (supports S/MUX II and IV) I will ideally have about 32 channels of audio available. I havent used the protools stuff before and was wondering if anyone has any better suggestions for shifting 32 channels of audio simulataneously... It would be best if the data can be accessed via a PC interface also. So basically a two part question - a) do I need two IO units - Ill go check it out myself just wondered if there were any PT gurus on here and b) should I be thinking about another solution? Many thanks for you thoughts.