1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Unable to control a JV1010, any suggestions?

Discussion in 'Pro Audio Equipment' started by bbtodrum, Feb 20, 2006.

  1. bbtodrum

    bbtodrum Guest

    Hello, im having some difficulty with a roland sound module JV1010. Im unable to change pathches and control it with my controller. I have a a Fatar's midi out connected to the modules midi in, the module identifies a midi signal. The module is set to Perform, but when I change the patches it doesn't respond, neither to bank changes. The only sound I can hear is a simple piano. Ive tried returning it to factory settings, but It doesn't help.
    Any help, somebody?.....



    Cubase Sx3, Powerbook 1.67, 2gRam, Fatar 1880, Tascam Fw1884, M5, EWSSymphonic,
     
  2. saemskin

    saemskin Active Member

    check the midi implementation chart in the JV's manual and make sure your controller is transimitting the correct information to make it do what you want it to do.
     
  3. huub

    huub Guest

    make shure on the front panel its on 'perform' not on 'patch'
    (edit: after i read your post for longer than half a second i saw you've done this..)
     

Share This Page