1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Undoing Changes

Discussion in 'Recording' started by SwurVe, Sep 27, 2005.

  1. SwurVe

    SwurVe Guest

    In ProTools...how do i go back into the program and undo changes....I have added too much reverb and I would like to take it off....I hope i can go back and change it....and i am in non destructive recording mode...im in the normal recording one iwth just the red dot...
     
  2. iznogood

    iznogood Member

    you cannot undo changes to the sends.... if that is the way you work...

    all edits can be undone up to 32(set i prefs) levels back... cmd+z on mac ctrl+z on windoze....

    you will learn alot if you read the basic editing chapter in the manual.... wich resides in pdf format on your hd...
     
  3. SwurVe

    SwurVe Guest

    im talking about after i have closed pro tools adn go back into it...im in non destructive mode
     
  4. iznogood

    iznogood Member

    then turn the down the send to the reverb
     
  5. SwurVe

    SwurVe Guest

    im not using the send...i did it using audio suite effects...it dont matter now i got it all worked out...thanks anywyas
     
  6. McCheese

    McCheese Well-Known Member

    All the audio tracks are in the bin on the right, every time you change a file in non-destro mode it'll make a new one, so figure out which audio file you need and just drag it over.
     

Share This Page