1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Universal Audio 2-610 into DBX 386...

Discussion in 'Recording' started by kountkris, Aug 14, 2008.

  1. kountkris

    kountkris Guest

    I've been saving up to buy the Universal Audio 2-610 to use in my studio, because of the amazing sounds I've heard come out of it. I noticed that it only has balanced xlr outs, which is good, but a little bit of a problem in my case. I need to get the Universal Audio 2-610 from the 2-610 to my computer. If I were to send the the signal from the 2-610 with the balanced xlr outs into my DBX 386 Tube Preamp balanced xlr balanced ins, then used the s/pdif out on my DBX into my Emu-1212m sound card, would I still be able to get the Universal Audio 2-610 tone? or would running it through the DBX 386 kill the tone or possibly make it better? If that will kill the tone, how can I get the 2-610 into my Emu-1212m with no quality loss?
     
  2. GeckoMusic

    GeckoMusic Guest

    The Emu 1212 has 2 balanced 1/4" line inputs right? Couldn't you build or buy a TRS 1/4" to XLR cable? That's what I use from my mixing console to my monitors. There's no funky impedance difference because it's XLR, it's still line level right?
     
  3. RemyRAD

    RemyRAD Well-Known Member

    You may have more money than talent? Your DBX 386 is already a preamp & digital interface and while you can plug your 610 into it, it's not going to make you sound any more talented, or improve your recordings. You're looking for the magic pill. What you might want to invest in are some quality converters like Apogee's. I don't even own those. My recording sound so good even mediocre converters do the job. Yours should too. What are you really looking for?

    Digi design & Roland converter inputs
    Ms. Remy Ann David
     

Share This Page