1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Using a Zoom H1 with 2 microphones

Discussion in 'Recording' started by Primrose, Dec 31, 2015.

  1. Primrose

    Primrose Active Member

    Hi

    I want to record interviews with a Zoom H1, a splitter-cable and 2 microphones (Giant Squid Gold Plated Microphone for Zoom H2 and the Giant Squid Omnidirectional Mono Microphone ). I get recordings from both mics but one of the speakers sounds OK and the other is lower volume and muffled. Please could someone tell me what I am doing wrong. Would it cause a problem if the mics is mono and the other is stereo?
     
  2. Boswell

    Boswell Moderator Distinguished Member

    What do you mean by a "splitter cable"? Is this a cable designed for plugging two headphones into a single headphone socket? If so, you are connecting the left input of the H2 to the left output of the stereo microphone, but the right input of the H2 is connected to both the right output of the stereo microphone and also the output of the mono microphone.

    Since the microphones draw their operating power from the input connector (they use "plug-in power"), it's not going to give good results on the right channel that is both powering and receiving signals from two microphones. The mono microphone has no connection to the tip contact of its jack plug.

    One thing you could try is to disconnect the ring connection on one of the output sockets on your splitter cable, and label that socket carefully so you only plug the stereo microphone into it. Leave the tip and sleeve connections as they are. Doing that would allow the right channel of the H2 to power and receive signal only from the mono microphone plugged into the other (unmodified) socket. You would have to use the stereo microphone as mono, with the left side of the microphone pointed towards the sound source.

    Good luck!
     
  3. Primrose

    Primrose Active Member

    Yes, it is a headphone splitter cable. I peeled some of the PVC sleeving off one branch of the Y - and then found that the battery on my continuity meter is flat! I look forward to getting a replacement and finding out which wire to cut.
    Thanks very much for your help.
     

Share This Page