1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Using Mults?

Discussion in 'Recording' started by Doublehelix, Dec 4, 2004.

  1. Doublehelix

    Doublehelix Well-Known Member

    I am using outboard mic pres, and I want to be able to split the signal so that one lead goes to the A/D and one to my console for monitoring.

    I have things wired through a half-normalled patch bay, and I can easily just split the signal that way, but I am concerned about the quality of the signal being degraded that way.

    I definitely want the best possible quality signal going to the A/D's, but also want to be able to monitor directly. Any suggestions or comments on the multing technique I describe?

    Thanks!
     
  2. Thomaster

    Thomaster Guest

    if you keep the wires short and use balanced ones, i dont think there should be a problem with loss of signal...
    of course, monitoring from your soundcard would make more sense, cuz you're then listening to how it'll sound like, after you recorded it.. that's what you want to sound good right?
     
  3. Doublehelix

    Doublehelix Well-Known Member

    Actually, this is for tracking purposes only (cue mixes), and I need latency-free monitoring for the talent.
     
Similar Threads
  1. Paladyne
    Replies:
    1
    Views:
    1,059
  2. backinthelab
    Replies:
    1
    Views:
    595
  3. Rolo06
    Replies:
    3
    Views:
    1,860
  4. ColdWarmth
    Replies:
    3
    Views:
    2,490
  5. rainsong23
    Replies:
    3
    Views:
    1,331
Loading...

Share This Page