1. Register NOW and become part of this fantastic knowledge base forum! This message will go away once you have registered.

Wiring Neutrik Combo Connectors

Discussion in 'Accessories / Connections' started by TomF, Jan 21, 2005.

  1. TomF

    TomF Guest

    Hi,

    I'm getting ready to solder up some Neutrik combo plugs (NCJ6FI-S) with Mogami W2534 cable. With these combo plugs do you run jumpers from the 1,2,3 terminals to the Tip,ring sleeve terminals T,R,S. And if so, using the quad wire should I use a single wire or double wire jumper. As for the shield and ground should these be jumped as well, with the ground then going to the steel UPC module box that these combo's are being mounted in.

    Any help would be appreciated.

    Thank you
    Tom F
     

Share This Page