Skip to main content

Monotor Reverb

Member for

21 years 2 months
I'm trying to get reverb to come through on both stage monitors I'm using. What happens is this: The left monitor gets a wet and dry signal OK, but when I try to add reverb to the right monitor, it only receives the dry signal and the wet part still only comes out of the left monitor. The monitors are being run out of Aux Sends 1 & 2 of a Mackie 1604 VLZ and I'm using an effects loop out of Aux Send 3 to a Yamaha Rev500 and back to the Mackie via Aux Return 1. The Rev500 has been set to mono input. Any help would be greatly appreciated. I also mistakenly posted this question as a Poll earlier. Sorry! --Dave


Member for

19 years 4 months

Kurt Foster Mon, 11/24/2003 - 11:41
Wow ... reverb in monitors usually adds to the likelyhood of early onset of feedback.. but if you insist..
The easiest way to get what you want is to return the reverb through a channel strip rather than the aux returns.. you can then send differing amounts of reverb to each monitor via the approriate aux send as well as the mains via the main fader.