x

Gen 3 Rokit Sub to Gen 4 Rokit monitors?

Unregistered Guest

Member for

1 year 10 months
redcat 27 May 2020
If I have the KRK gen 4 Rokit 8 monitors, but then I found a Gen 3 KRK K10s Powered Sub, it's gonna run just fine right? There's no reason I shouldn't hook this up?

Comments

boswell

Member for

15 years 7 months

Boswell Thu, 05/28/2020 - 00:49
It should work fine. Cable your DAC or mixer outputs to the inputs of the sub and the high-pass outputs from the sub to the speakers. The only tricky thing may be getting the relative levels correct between the sub and the mid/tops.

The KRK 10S has a jack for a bypass switch. A handy tip is to get a footswitch of the type used for toggling guitar effects and use that for switching the sub in/out. I use it all the time for checking the low end balance in mixes.
Unregistered Guest

Member for

1 year 10 months

redcat Thu, 05/28/2020 - 00:51
Boswell, post: 464441, member: 29034 wrote: It should work fine. Cable your DAC or mixer outputs to the inputs of the sub and the high-pass outputs from the sub to the speakers. The only tricky thing may be getting the relative levels correct between the sub and the mid/tops.

The KRK 10S has a jack for a bypass switch. A handy tip is to get a footswitch of the type used for toggling guitar effects and use that for switching the sub in/out. I use it all the time for checking the low end balance in mixes.
Thanks!

Tags

x
↑