Skip to main content

Help with Static in Audio Loop

I have an MXL 770 Mic that runs over a Roland XLR cable to a Roland Rubix 22 Audio Interface. Pretty much everything in my loop is brand new and Im getting this horrid background noise all the sudden.
No matter which mic I use I still get the same static.
Whether I have a mic plugged in or phantom power on or off I get the same static result.
Can anyone help me figure this out?

https://recording.o…
Attached files static Example.mp3 (75.4 KB) 

Comments

Boswell Fri, 02/07/2020 - 03:09
The L and R channels in your clip are very similar but not identical, so does this mean that both channels on the interface exhibit the same behaviour? Is the amplitude of the noise independent of the position of the gain trim controls ("SENS" in Roland-speak)?

If the answer to these are both "yes", I suspect that the Rubix 22 has developed a fault such as an internal dry joint. Since you say it is brand new, I would return it for replacement.

Boswell Fri, 02/07/2020 - 08:51
Huntertreat14, post: 463297, member: 51836 wrote: I have an MXL 770 Mic that runs over a Roland XLR cable to a Roland Rubix 22 Audio Interface. Pretty much everything in my loop is brand new and Im getting this horrid background noise all the sudden.
How can the noise be "all the sudden" if your previous interface was doing the same thing and so you went out and bought a new one? It's not easy responding to problem descriptions that don't give important information.

Since you have changed all the audio equipment and the problem is still there, what audio software (DAW), type of computer and version of operating system software are you using?

Tags

x

Register

Your recently read content