API 205L

The new API 205L Instrument Direct is specifically designed to accept a guitar or bass

  1. Press
    The new API 205L Instrument Direct is specifically designed to accept a guitar or bass direct into it, without any loading on the pickups. With the use of the unique TONE control, the low end "mud" can be reduced. Turning on the BRIGHT switch adds clarity, like the bright switch on any amp. The combination of these two functions may eliminate the need for any EQ on the instrument when recording, keeping the signal pure.

    The input of the API 205L is designed specifically to load a pickup the same way that a tube guitar amp would, retaining all of the tone, and minimizing the loading effect on the pickup. This minimal path eliminates the need to use a standard direct box, which more times than not, only converts the signal to a balanced mic level output, which still requires a mic input, equalizer, and fader to get the signal to a recordable level.

    The API 205L is capable of boosting any instrument to a hefty line level without additional amplifiers. With the 100 K LOAD switch, the tone of the pickup can be altered slightly, which tends to darken the high frequency content. The BRIGHT switch adds a treble boost in the same manner that most instrument amplifiers do, clarifying the instrument and adding presence to it without the need for outboard equalization. When inserting an instrument with an internal preamp or a line level instrument such as a sampler or a keyboard, the 205L has a 20 dB PAD switch to drop the level without loading, retaining the full range of the 205L and its features.

    When used with other 200L series modules, a complete input strip can be built from input through dynamics, equalization, and final output. With the addition of the 201L fader module, the output level of the 205L can be adjusted so it is compatible with the input of any guitar amp. The artist can then be in the control room while the instrument amp is isolated in the studio.

    The API 205L Direct makes use of the 2510 and 2520 op-amps and therefore exhibits the reliability, long life, and uniformity characteristic of API products.
    • Wide range GAIN control
    • Hi-Z input, like a Tube Amp
    • Thin
    Number of Bands : Two

    Filter Type : Passive Shelf

    Filter Frequency Centers : Low: 150 Hz

    High: 8 kHz

    Input Impedance : >470 K Ohms, Un-Balanced

    Output Impedance : 85 Ohms, Transformer coupled, Balanced

    Nominal Levels : -40 dBu to +20 dBu

    Clipping Level : +28 dBu

    Frequency Response : 0, -.3, 30 to 20 kHz

    Noise : 98 dB below +10 dBm output, unweighted. 20-20 kHz

    Distortion : THD: .02% (+4 dB @ 2 K)

    Connectors : .100 spaced ELCO

    Size : 1.25" X 2.65" X 6" Deep

    Shipping Weight/Actual Weight : 1.5 lbs./1 lb.

    Power Consumption : ±16 Volts DC, 80mA max at +24 dBu out
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice