Which order do you advise when recording to analog tape, the following...
The kick drum channel on the mixer would have a noise gate,compression and parametric linked in to the insert.
I was going to do...out of the insert into the Eq into the compressor into the noise gate and back into the desk.
What the best route?
Thanks.

Hi, I have an audio cassette that I am going to transfer to digital.

One of my UA 1176LN input pots (UREI 600 ohm T-Bridge Input Pot for UREI/ UA 1176) started getting scratchy. It was under warranty so UA replaced it.
I have another 1176 here which could start acting up some day too so maybe I should be looking for a backup (or two) now.

I contacted PEC, the company that made these for UA, asking if they had one and what it would cost me.

Hello everyone,

So I know there's a few posts out there on this topic already so you'd think I could make my mind up but I'm actually torn! I don't have access to play any of the options I'm considering, so I'm reaching out for help.

I'm looking at the following spring reverbs

I would like to analyze analog circuits by sending a stimulus through it and then recording the output, changing the circuit slightly and then running the test again to produce two *almost* identical .wav files that can then be compared sample-for-sample.

http://www.littlelabs.com/vog.pdf

Ok, I know nothing can't beat the real thing. Thing is I don't have the money for a Neve console or ssl outboard processing.
So the question is, which plugin or plugin combination will bring me close to the real thing ?

Hey everyone,

I have a Pro 40 and mainly run over the FW to the DAW and use the monitor outs for my near-fields.
What would one use the Pro 40's eight analog line outs for ?

Hi. I've got Allen and Heath Zed 24 and few rack units connected to it. My question is : what interface should I get to be able of mixing on the desk? I would like to have separate tracks coming out of Cubase to the desk and then stereo main recorded back on daw. Thanks for your help folks.
Tom