Skip to main content

cable with lowest noise floor canare belden mogami?

i have a few cad e100s's on the way and if what i have seen is true it has a very low noise floor, 3 point something dba, and i wanna keep the "low noise" signal going, so does anybody have any opinions on which cable has the lowest noise floor?
i'll be running them very short, around 15 foot or less
any help thanks

Mixing Stereo and Mono interconnect cables in system?

About to hook up my friend's recently purchased equipment and went to Guitar Center this morning to get the interconnect cables.

I am hooking up starting from top to bottom:

Numark Mixer into
Peavey EQ into
Rane AC22 Xover into
Crown MT1200 for bass and MT600 for mids and highs

Help! What cables/setup would i need for this amp?

Hi everyone,

I have been reading along for a few months, and i decided to buy a Headphone and use a Amp i still have laying around with it.

Buuut, my knowledge is almost zero with plugging this kind of equipment in, and i would like to know how this works before the equipment arrives.

My setup:

Bulk Snake Cable Recommendations?

Lots of discussion of brands of basic mic cable in the archives, but I can't find any discussion of preferred brands of snake cable. Hardware recommendations would also be a help. I'm looking into making a 24 channel fan to breakout box, and maybe a couple of xlrf-xlrm subsnakes. I'd appreciate any help with brands and suppliers.

Line/Mic Level Cables

Forums

I need some consultation about certain applications of Line Level and above audio signal with regards to using the right cables. I have begun building my own cables from bulk cable and connectors. I am re-cabling my guitar rig and recording rig, so far the guitar rig is taken care of (for the most part) but I need some advice for the recording rig.

Tips for cables-starquad

Well, I was working with Canare star quad (L-4E5C) today. I had to remind myself about some helpful hints for dealing with the braid. One does not want to cut the braid at all so how to un-braid it? Dental pick. Actually what I have isn't quite a dental pick but it is close and a pick. Carefully cut the sheath and pull that off.

Help! Groove Tubes 6TM Power Supply cable Pin out schematic/ ADAT Elco to 1/4" snaKes

I have an old Groove Tubes 6TM mic with the PS1 Vacuum tube power supply. The mic end looks like the Groove Tubes EC7 cable in that it has a 7-pin connector. The power supply end looks like an 9-pin ADAT sync connector almost like a vga computer display connector. I am in need of the pin out configuration so that I can build one or a source to purchase one.