Hello All,

New here but been doing this since the 300 Baud days of BBS'es
(So probably know some of you cats!)

Hey guys,

I'm looking to record without Micing an amp or using desktop/software amp modelers. Would this be possible, correct to do this for signal chain:

Guitar > Guitar Cable > Guitar Rack Preamp (ADA MP1 or Marshall JMP1) > Stereo Cable > Apogee Duet FireWire Interface Line In > MacBook Pro > DAW

I have a stupid question!

Hello there,
I was lucky enough to get two BFE MV1 Preamps and two BFE MK2 Eqs..
But unfortunately I didn't succeed in finding a rack or console yet to test them.
Has anyone experience how a DIY construction could be made or does anyone offer that service?

Hello,

I've wanted to start filling up a Danner (german broadcast modules) rack for a long time, and now that I have a pretty good idea about how to rack them I need to choose which ones to get, or more precisely, how to configure the rack. So here are the last remaining questions I have on the subject:

So I recently purchased an Eleven Rack. And the sounds that I was able to get out of it was really impressive...for me... And in your face! And because of the DSP chips, and low latency monitoring enabled on Pro Tools, there is no audible latency. My question is, what are your opinions of it?

Ashfall Production Studios, sent from my iPhone 4.

Hi everyone.
I have couple of questions regarding some '95 issued AMEK MOZART I/O modules, in particular the MZ-11 and MZ-15RN:

I have located the schematics of the MZ-15RN module. And I have made a PSU for 2 modules with +/- 17.5VDC and AGND (analog?) and +5VDC and DGND (digital?). There are rails for these voltages on edge connector J2.

I need to consolidate 3 preamps that aren't rack friendly. I have an api 512c, purple biz, and a groove tubes brick. I want to be able to replace those with a one or two space, 4 or 8 channel preamp. what do you recommend. I want to be able to have all my interfaces and sh*t in a 10u case for ease of portability between my three locations I record at.

Wondering if I put my EMU E6400 sampler or a Yamaha MG 16 mixer on slider drawer in the same rack as the DAW ( PC on bottom Emu/ mixer a couple of spaces above it )
Would there would be any noise, hum etc picked up by either ?

I am running out of rack space trying to keep things within arms reach.