Hi, Im an up and comeing MC form the UK I'm 17 and have been writing music since i was 12 i was working with various top producer like Zed Bias from Sidewinder and others but now I'm trying to start my build my own studio but atm i jus need to record some tracks to make money to put into the studio equipment. I have some backing instrumentals and just need to put my vocals on them.

I do this all in my bedroom at home... I am not looking for a professional result, but anything that could cut down on picking up extra room noise. Hang up blankets? Sing in a corner? I appreciate any help. I use a RODE Nt2-a if that makes any difference, and it goes in through my firepod. Thanks!

Hi Everyone,

My name is Uzair, and i want some help in setting my home studio. I have the following hardware:

1- Toshiba Intel Core2 Duo Laptop
2- Audio-Technica AT2020 condenser microphone
3- Tapco Mix (by Mackie) 260FX Mixer (to use as audio interface)
4- Behringer U Control UCA202 USB Audio Interface

Hello. I am recording a singer who has a very loud upper range, and often clips out when recording. However, when she drops down in her lower range, she is almost inaudible. The signal chain runs as follows:

Cardoid condenser mic
/
PreSonus TubePre
/
Behringer Compressor
/
Alesis Multimix
/
PC via usb

Hello,

Im farley new to the music thing. Im trying to learn as much as I can.

My question/problem I have is Im using a cheap o CAD USB Mic to record directly into Logic.

Problem: Vocals are way too loud they hit the clip point even if i lower the volume slider on the track I'm recording on to lets say -20db it still clips.

I tend to record 3 vocals track for every piece of the song like hook, verse etc.. Then I pan one to the left, one to the right and leave one vocal in the center. I add the same eq, reverb and delay to all of them.
I heard you can record with only one vocal but if so how do u get it to sound nice and warm like if I used 3 vocals.

Thank You For Your Time

Basically every time I attempt to record on Cubase both my beat and my vocals record on one track, so basically as I record Cubase record both my vocals and instrumental at the same time which leaves me with a instrumental as one track, and vocals and instrumental as anouther track, something is wrong here the vocals should be recoreded on their own seprate from the instrumental.

Hello!

Our band is going to record a demo of the whole album to make sure we like all arrangements, before we go to the studio and go broke.
We steel want it to sound as good as possible.

My goal is to record acoustic guitar and vocals at the best quality and then if i want to add some drum tracks i can just go to a commerical studio and add on to it after. Then once it's done i can get it sent for mastering. That would save a lot of money in the longrun.