Aardvark Q10 + Meek MQ3 + FMR RNC

Discussion in 'Converters / Interfaces' started by jdier, Sep 30, 2003.

  • AT5047

    The New AT5047 Premier Studio Microphone Purity Transformed

  1. jdier

    jdier Active Member

    Mar 20, 2003
    Home Page:
    In about a week and a half I will be hooking up my MQ3 Pre and my FMR Really Nice Compressor to my Aardvark Q10.

    I am looking for any advise, guidance, auggestions, experiences from users who have used either the meek or the rnc with a Q10.

    Here is my quick plan.

    Plug my Vocal Mic directly into the Meek then use 1/4 to 1/4 inch patch from the Meek into the front of the Q10, likely channel 5-8 (one that does not have phantom power already)

    ?? Two outs on the Meek, are they identical? Why are there two? Which should I use?

    FMR RNC:
    Use Y cable (TRS to two 1/4inch phono plugs) from the insert on back of Q10 to the Left (or mono) IN on the RNC and back from the Left (or Mono) OUT

    ?? If I have matched mics recording the same source (acoustic guitar, drum overheads, drum room mics) can I take those two channels from the Q10 inserts each to one of the INs on the RNC (Channel one to Left, Channel two to Right)?

    Any cautions, concerns or thoughts on my plans?

    Thanks in advance.

  • AT5047

    The New AT5047 Premier Studio Microphone Purity Transformed

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice