Automation, clip gain or compression?

Discussion in 'Mixing & Song Critique' started by ingham210, May 14, 2017.

  • AT5047

    The New AT5047 Premier Studio Microphone Purity Transformed

  1. ingham210

    ingham210 Active Member

    Joined:
    Mar 20, 2017
    Location:
    Australia
    Ok so I've been learning a lot about this whole mixing game. I've done some mixes for some university projects and I'm starting to get somewhat of a hang of it. However, there's one thing that I can't quite decide on.

    I know that compression is used to reduce the dynamic range of a signal, and automation is used to control the faders (but can also be used on things like pan and effect parameters). I also see the clip gain option in pro tools and I understand that.

    Where I'm having trouble is knowing which one to use. For example, I have the stems of one of my bands songs we recorded. Essentially the song has a quiet intro and verse, a loud chorus and solo, and then it repeats this cycle. We recorded the guitars and bass for the soft and loud parts at different gain levels to get the best possible signal. However, the vocals and drums were done at the one gain level because there aren't any gaps in the arrangement and they also transition from soft to loud within a few beats. I'm not sure which order/method to use in this case.

    A few things spring to mind:
    1: Do I compress the drums and vocals, or do I automate them? Or do I use clip gain (only on the vocals)
    2: How loud should I aim to make each section? Generally I leave about -6dB headroom on the master fader for anything loud, so should I bring up the soft sections until they are -6dB?
     
  2. bouldersound

    bouldersound Real guitars are for old people. Well-Known Member

    Joined:
    Jan 23, 2010
    Location:
    Boulder, Colorado
    Home Page:
    I often use all three. Clip gain to even out levels, compression to taste, then volume automation to fit the vocal to sections.

    Don't aim for a specific amount of headroom or a specific peak level. Keep average levels around -18dBFS and let peaks fall where they may.
     
    Mahzin likes this.
  3. ingham210

    ingham210 Active Member

    Joined:
    Mar 20, 2017
    Location:
    Australia
    Ok thanks
    Is there one instrument in this song I should base the level for the other parts off of?
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice