Checking for out of phase in Protool

Discussion in 'Mixing & Song Critique' started by JT916, Mar 21, 2002.

  • AT5047

    The New AT5047 Premier Studio Microphone Purity Transformed

  1. JT916

    JT916 Guest

    Can you help?

    i got a final mix handed to me. I am a little worry that something is out of phase.

    Is there a way for me to check if the stereo file I got is in phase, using protool.
    cause I don't have anything esle to use for checking

    thank you master.
  2. anonymous

    anonymous Guests

    Feb 10, 2001
    Compare the waveforms on the left and right tracks. If one is going up when the other is going down you have either a polarity or phase problem. If it is polarity (waves in mirror image) you can flip either the left or right (obviously not both!) using either the Trim plug-in or the Audiosuite Invert.

    If it is a phase problem, one side is shifted either a little earlier or later than the other. In which case nudging one of them forward or back so that the peaks and valleys line up will fix it. In a final mix of a multitrack session, though, it is likely that any phase problems were only on some of the tracks, not all, that were being mixed. This makes it more difficult to deal with, because by nudging one side of the stereo mix, you may bring one element back into phase while throwing off something else. Fixing it may require remixing.
  • AT5047

    The New AT5047 Premier Studio Microphone Purity Transformed

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice