In-line Condenser Mic High Pass filter

Discussion in 'Microphones (live or studio)' started by DanValda, Dec 17, 2006.

  1. DanValda

    DanValda Guest

    Hello,

    I was wondering if anyone out there can help regarding adding a passive high pass filter circuit between my condenser mics and mobile pre-amp.

    This setup is for collecting samples in the field - a pair of Rode NT5's, with a M-Audio MobilePre USB preamp supplying the phantom power. At this stage, I don't want to replace these (lack of funds).

    One problem I'm having, is that neither the mic or the pre-amp have a high pass filter, and I would much prefer to remove unwanted low frequency content before the rather low-spec'ed pre-amp section, than later in the chain.

    I have some basic electronics knowledge - but not much, so was wondering if anyone out there would have any a circuit diagrams, or ideas, that would allow me to build an inline passive high pass filter to work in this setup (or another way to look at it is: as a mod to the MobilePre).

    Please note: I haven't found any circuits like this via my web searching, and I think I have exhausted the possibilities of physically reducing low frequency content.

    Thanks in advance,
    Dan
     
  • AT5047

    The New AT5047 Premier Studio Microphone Purity Transformed

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice