Last Stupid Question . . . I Promise

Discussion in 'Microphones (live or studio)' started by Renegade, May 31, 2003.

  • AT5047

    The New AT5047 Premier Studio Microphone Purity Transformed

  1. Renegade

    Renegade Guest

    I tried micing my Hiwatt Custom 100 and going direct with my PRS straight into the board through boxes and onboard effects, yet when it comes to a nice grinding, crunch sound I end up witha buzzy overdistorted guitar. Is there some magical piece of equipment I am failing to run it through?
  2. Kurt Foster

    Kurt Foster Well-Known Member

    Jul 2, 2002
    77 Sunset Lane.
    Mic the amp at the edge or in the middle of the speaker cone with a 421, D112, RE20 or a SM57. Directly in the center will make it very bright. Try to keep the pre amp gain as low as possible. A really nice mic pre will be a lot of help. Try a little compression, 2 to 1 ratio with a medium attack and a fast release, about 3 or 4 dB of reduction. After that, adjust the tone of the AMP to taste for the right balance in playback.
  3. Pez

    Pez Active Member

    Dec 27, 2002
    I would try something other than a PRS guitar if it's possible. For a good crunch try a Les Paul through a Plexi Marshall or an old black face Fender amp. The build quality of the PRS guitars is excellent but I've had a harder time getting a good sound out of them. YMMV and It's just my personal opinion so don't be offended if you're really attached to that guitar. The most important thing in recording is getting a good sound at the source. If you have that you could throw up a cheap 57 and kick some ass.
  4. rpowell

    rpowell Guest

    Heavy guitars always seemed like one of those things that just takes practice for me..probably because i'm a guitarist by nature..

    I play a prs as well..and have found it a little more difficult to record..but just takes a lot of practice.

    Try using less drive/gain/distortion..what you're hearing from 10' back is quite different than a close mic.
    If you can..mic the amp..and track from a different room and have a friend move the mic around to see where it sounds good..
    or..track a bit yourself move it, etc

    hope this helps
  • AT5047

    The New AT5047 Premier Studio Microphone Purity Transformed

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice