Midi Drums..Snare changing pitch

Discussion in 'Converters / Interfaces' started by Potts, Jun 15, 2011.

  1. Potts

    Potts Active Member

    Joined:
    May 14, 2011
    Home Page:
    So we laid down some drum tracks tonight.

    V-Kit--->M-Audio INterface--->Cubase 5

    I went back after the session and ran the tracks through EZ Drummer (I know- that's all I have at the moment) and I notice the pitch of the snare changes throughout the tune. It actually sounds like it has chorus on it.

    I'm at a loss and must figure out how to fix this. I cant hope to cover it up in the mix later because I want a nice consistent snare throughout the song.

    If it helps, he's doing a military type of roll on the snare during said parts. Any advice or trouble-shooting help would be great.

    Thank you!
     
  2. Ripeart

    Ripeart Active Member

    Joined:
    May 13, 2011
    Location:
    Miami, FL
    Home Page:
    It could be that the velocity of the original snare track is variating enough to cause EZ Drummer to change the way the sample is triggered. Is there a setting that detects velocity? If so you might try making that less sensitive.
     
  3. Potts

    Potts Active Member

    Joined:
    May 14, 2011
    Home Page:
    Thanks Ripe...I found out what it is but I'm not sure what is causing it...

    I opened the drum editor and realized that every single strike on the entire kit is doubled. I actually went in and deleted all the double hits and obviously it's fine. Any ideas why this may have happened?
     

Share This Page