Neumann KM56 & N52a power supply

Discussion in 'Electronic Repair Modifications DIY' started by verslo, Oct 5, 2006.

  1. verslo

    verslo Active Member

    I'm trying to figure out how to wire my Neumann KM56 to a Neumann N52a power supply. I'd like to know which pins on the 6 pin tuchel connector at the mic go to which pins on the rectangular 12 pin tuchel connector (1a to 6a & 1b to 6b) on the N52a. I'm aware that 220vac goes to 6a and 6b but I'm unsure of the rest. I got my hands on a schematic that was cut off on the right side and I'm not up on my German...Can someone please give me a pin to pin breakdown so I can fashion a cable? Please pardon my ignorance and thanks!!
  2. verslo

    verslo Active Member

    Please don't all chime in at once...
  3. DIGIT

    DIGIT Guest

    please, don't post the same question multiple times.

Share This Page