Pro Tools Monitoring

Discussion in 'Monitoring' started by hbj, Jan 25, 2004.

Thread Status:
Not open for further replies.
  1. hbj

    hbj Guest

    Does anyone here know of a clean-sounding box that can essentially serve as a monitor section for ProTools? I.e., the L-R of Protools would feed this box through a volume pot (and possibly a mono summing bus) and then right to the monitors? I'm using a Mackie mixer now which has three individual gain stages, plus an unswitchable EQ. All that can't be helping the signal!

    I know Coleman audio makes the M3PH, but it's -SO- expensive. Anyone know anything good but cheaper?

    Thanks!

    ----------------------------------------------------------------------------------------
    I've moved this to the Plugs, Mixing, Hardware forum. Mackie debuted such a unit at LA NAMM and Samson has the C-Control. I'm sure there are a few other units out there as well.

    [ January 25, 2004, 04:10 PM: Message edited by: AudioGaff ]
     
Thread Status:
Not open for further replies.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice