ROMP Mastering Chains

Discussion in 'Mastering' started by 20to20, Mar 23, 2002.

Tags:
  1. 20to20

    20to20 Guest

    Hey All,

    I just finished working on the ROMP tune and I thought
    I'd start a thread on the Gear/Procedures that
    each engineer used to complete the project...

    Unfortunately, since I don't use a DAW,
    I couldn't really take advantage of the 24bit mixes
    (too bad there wasn't a CD24 mix for the Masterlink users)...

    First, I played the 16bit mix through my Finalizer
    (w/no dither) to convert to Analog while boosting
    the overall level a little for the next stage...

    Then, I went thru the FATSO for just a dusting of
    Saturation, Warmth and Tranny (I used no Compression here)...

    Next, thru the Avalon 747's Valve Circuit and
    Compressor (2.5:1, long attack, quick release,
    threshold set for just a couple of dB gain reduction...
    Then thru the 747's graphic EQ to slightly dip the
    lower-mids and to add some high air...

    Finally since I'm borrowing a friend's
    Apogee Rosetta, I ran the mix thru it for
    the UV22HR and the Soft Limit...

    Resulting in a mastered mix that is powerful
    and robust, without being squished to death... ;)

    Then into the Masterlink to burn a Redbook CD...
     
  • AT5047

    The New AT5047 Premier Studio Microphone Purity Transformed

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice