Setting monitor levels / balance?

Discussion in 'Monitoring' started by arothman, Aug 27, 2003.

  • AT5047

    The New AT5047 Premier Studio Microphone Purity Transformed

  1. arothman

    arothman Guest

    Hi there!

    I've just purchased my first set of 'real' monitors... the Blue Sky ProDesk set. I want to make sure that I'm getting the 'true balance' between the low and high end on the system... that I'm hearing the actual level of the bass in relation to the highs. I'm wondering if there is a standard method for setting the levels of the two mains and the sub using some noise and my handheld SPL meter?

    Also, is it 'easier on the gear' to leave the monitors turned on all the time, or to shut them off and only power them up when I'm going to use the system? I know that computers seem happier when they're left on constantly, or in 'sleep' mode... but I wasn't sure about monitors. I don't want to be hard on the power supplies and amps if I can avoid it!

    Thanks all,
  2. Ammitsboel

    Ammitsboel Well-Known Member

    Aug 12, 2003
    It would be best if the sub is placed as close to the mains as possible.

    Don't worry about power up and down, the speakers are "actually" ment to be used in a pro inviroment.

    But it's gennerally good to "warm" your equipment up before you use it(15-30min)
  3. arothman

    arothman Guest

    Well, the mains are sitting on my desk and the sub is on the floor right behind it, so that part's handled. Mostly I'm wondering about setting levels so that I'm getting the right balance of sub-to-main...

  • AT5047

    The New AT5047 Premier Studio Microphone Purity Transformed

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice