Tannoy Reveal tweeter mod

Discussion in 'Monitoring' started by halfasemitone, Aug 25, 2010.

  1. halfasemitone

    halfasemitone Active Member

    Aug 20, 2010
    Alberta Canada
    Hi all,

    I've heard about tweeter replacements and mods for monitors due to the limitations of what they can produce. I have a pair of Tannoy Reveals (passive) and want to replace the tweeter. I've read that ribbon tweeters are the way to go. Plus some go all the way up to 60kHz where as my Tannoys only go to 20kHz. Although I know I won't be using the full 60kHz it would be nice to breath some new life into these "dark" monitors that I've been using for so long. I use an R300 interm amp but will be replacing it with a Halfer DH500.

    Any thoughts on the tweeter replacement/mod or the amp I'm about to swap out?

    Thanks to all in advance.
  2. Mckey

    Mckey Active Member

    Jan 4, 2007
    I think this is a little misguided. You more than likely don't even hear 20k. That's where a lot of manufacturers just stop referencing their gear to. When you see something that says 20hz-20k it doesn't mean it stops at either end of those, it means its full-range. More than like the tweeters in the tannoys go to 30k. But other than the advantage of not messing up harmonic content that could mess up what you do hear, its pointless. Especially if you're not sending much above 20k to the monitors in the first place. I only hear up to 18k in my good ear, and I'm 23 with good ears. 20k is usually only possible with kids around 12 years old when your ears are prime and haven't been abused by loud concerts and explosions. I don't personally know anyone my age or older who can go to 20k. I'm sure there are a few select lucky bastards, but I don't know any of them.
  3. bouldersound

    bouldersound Real guitars are for old people. Well-Known Member

    Jan 23, 2010
    Boulder, Colorado
    Home Page:
    I suspect Tannoy spent a bunch of money to develop those speakers, including addressing phase alignment between the woofer and tweeter at the crossover point. If you have the R&D capacity to get the replacement tweeters to align properly then go for it.

    I also suspect that the "dark" sound of the monitors has nothing to do with lack of response above 20kHz and everything to do with the response below 20kHz.
  • AT5047

    The New AT5047 Premier Studio Microphone Purity Transformed

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice