When I connect my Mackie cr1604's "aux/monitor outputs" channel 2 to the quadraverb's input, then I connect the "aux returns to master" channel 2 to the quadraverbs output I should get the desired effect if the aux pot and the aux level are set to unity, correct? I hear the guitar coming out of my monitors but there is no effect of the guitar. The LED on the quadraverb doesent even pick up the guitar. What am I doing wrong? Am I doing something wrong? Help me out.
Thanks
Clint
Comments
is the aux send master out turned up? are you using a stereo or
is the aux send master out turned up? are you using a stereo or mono cable? also try aux sends 3 or 4 just for fun.....
Assuming you want Aux 2 send to to to your 4verb and Aux 2 retur
Assuming you want Aux 2 send to to to your 4verb and Aux 2 return to be the wet efx, here's what I'd do:
1. Connect 1604 Aux Send 2 to the 4verb L input.
2. Connect 4verb stereo output to the 1604 Aux return 2 L-R
3. Dial up Aux Send 2 on your guitar channel (some channel between 1 and 16) to U.
4a. Bring down "To Aux Send 2" to -infinity. This will prevent feedback when you do step 5.
4b. Bring up Aux Send 2 to U in the upper right-hand section (about 2" from where you could plug in a lamp, if you had one).
5. Bring up Aux Return 2 to U (between the knobs listed in 4a and 4b).
6. Rock out.
Did I get that right? Did you forget step 4b?