Gday all, i have a question about getting 3 firefaces to appear in SX as 3 seperate devices for I/O to my console.
At present i use both the ADAT ports to route things to and from the 1st unit to each other unit, becasue SX only see's the I/O of the 1st unit.
Has anyone got or seen a setup similar to this that might know more.
I hope this makes sense, it is a bit crazy. I can explain more if needed...
cheers
Steve.
Comments
does the rme software recognize the other units
does the rme software recognize the other units
yeh, the rme software see's everything ok, and everything works
yeh, the rme software see's everything ok, and everything works to the console etc...
i would like to see in the SX I/O setup that i can select unit 1 outputs 1-28, unit 2 outs 1-28, unit 3 outs 1-28...this way i free up the adats and it makes the routing in totalmix(s) less of a nightmare....
If you are on OS 10.4 or later you can combine control over mult
If you are on OS 10.4 or later you can combine control over multiple devices under Aggregate Devices, then all three devices will appear as ONE device to SX.
Audio/Midi setup utility found in the utilities folder.
8)