Anybody know of a reasonably priced outboard M-S decoder box with line level(+4)XLR ins/outs?
AEA sells one that has some extra tweaks(width control, etc.) but it runs at about $600 list.
I've seen some partial circuit designs posted. They seem fairly simple, but they've been either unbalanced or incomplete.
Any thoughts?
Tags
Comments
The only advantage I can see of a dedicated M/S decoder would be
The only advantage I can see of a dedicated M/S decoder would be in a live-to-two situation, where you need to get the correct stereo imaging onto tape, rather than decoding it later during mixdown.
I've only used M/S a coupla times, but in both instances I decoded after the fact using three channels on the desk and hard panning/flipping polarity, as described above.
Here is a decent article on the subject along with some links fo
Here is a decent article on the subject along with some links for DIY decoder boxes.
For DIY decoder you can also check PAIA kit at: http://www.pa
For DIY decoder you can also check PAIA kit at:
any three channels with polarity reverse on one and the ability
any three channels with polarity reverse on one and the ability to pan will decode M/S (analog or digital)...when spend money on a dedicates matrix?
Formula:
M channel: Pan center.
S channel number one: Pan left; polarity normal
S channle mult( a copy or mult of the S channel): Pan right; polarity reversed.
So, M is up the middle and gives you your mono center/image. The Left S+ and right S- channels give you your stereo/side information.
Play with the balance, though the combined S+/S- channels can start around -3db relative to the M channel.
[ December 02, 2003, 12:28 PM: Message edited by: RecorderMan ]