hi friends. I was transferring some ADAT/dm800 tracks to my PT TDM system, light piped via ADATbridge 24 bits/44khz and at empty tracks i get a readout of -114db instead of -00.
is that jitter, white noise? yes, it is a digital connection, quite funny ..
so?
:p
Comments
hey, what about some Bill Roberts and Steve Devino on this issue
hey, what about some Bill Roberts and Steve Devino on this issue?
:)
Hey ACB. I noticed that a rather lengthy, informative post from
Hey ACB. I noticed that a rather lengthy, informative post from Bill has been deleted on another thread. Something weird going on here, it seems.......
Hey Cycle, Kurt What is the reason for that? I have not notice
Hey Cycle, Kurt
What is the reason for that?
I have not noticed that
:(
Might be, it has to do with the 20 Bit output of the ADATs???
Might be, it has to do with the 20 Bit output of the ADATs???
n
Mode One: trasnferring DM800 tracks, connected to a DIF800 ( co
Mode One:
trasnferring DM800 tracks, connected to a DIF800 ( converts R-Bus to lite pipe), going there to PT Adat bridge
Mode two:
transferring 18 bit ADAT XT tracks to PT Adat Bridge.
In both cases, the -118dB signal was present, no matter if were blank track tapes or re-formatted clean edited ones.