Im looking to pickup some good mic cables and noticed there are quite a few differnet types.
Some being Hi-z, some Lo-z. What is the differnce and what would be a good mic cable type and brand for dynamic/condensor mic. thanks
Tags
Comments
Ragele , the difference is in the electronics a low Z input is l
Ragele , the difference is in the electronics a low Z input is like a mic pre/input to a mixing board (300-600 ohms usually) with a XLR ( round 3 pin connector ) a hi Z input is like a guitar input on an amp it has a 1/4" phone plug ( like on your guitar ) these are in the 5000-10000 ohm range ) they do not overlap IE sending a high Z input to a low Z input will not work very well and vis-versa.
The different cords you can by ( mic cable etc.) are sorted by quality mainly Radio Shack = crap , this is because the cable itself is of low quality , the better the cable the better the sound 90% of the time ( of course if the sound source sucks so will the recorded sound)
Moral BUY GOOD CABLES
I hope this helped
Later
Buzz
hello ragele,'Z' is the letter in electronics that refers to 'Im
hello ragele,
'Z' is the letter in electronics that refers to 'Impedance'. So what you are looking at are Low Impedance and High Impedance cables.
Off hand, i would say low z, but it would be best to try to find out what your microphone manufacturer recommends as far as using low or high z cable.
greg