Skip to main content

At the moment I'm using a RODE NT1000 to record a girl with a very soft voice. Without eq she sounds very boomy and dull. To make her sound better I roll of the bottom and boost around 2k. I'm thinking that I might get better results by buying a mic that fits her better in the first place. Right now I'm using Mackie preamps but I plan to buy a Phoenix Audio DRS-1.

So do you guys have a suggestion for a mic which has very forward mids and tight (and not too prominent) bottom? I want her to sound very present and "in your face".

My budget is kinda flexible but I prefer something less than 2000$ Until now I have considered the AT4033 or a Gefell MT71s.

Thanks

Tags

Comments

anonymous Sat, 03/12/2005 - 05:35

The u99 and u87 are both around 3500$ here in europe. I guess I could afford that but it would be kinda problematic. Also I think that it may be overkill since I like to put lots of eq, delay and sometimes vocoder on the vocal, and thus the small differences will disappear.

Since I don't have any sibilance problems at all, the 4033 might not be a bad choice. However I'm a little afraid that it will sound too thin and brittle?

zemlin Sat, 03/12/2005 - 08:47

Another thing - make sure you're playing around a LOT with mic technique. I don my headphones, take the mic in my hand, and with the talent singing I move the mic all over - high, low, straight-on, near, far, off-axis ... I recently heard of a fellow getting good results by putting the mic in the corner of the room and singing into it there - apparently the reflections gave him the sound he was looking for.

anonymous Sun, 03/13/2005 - 13:13

I think that you need to look for a microphone with a greater sensitivity than the average condenser microphone.
The Brauners, if you can afford them, will do. I bought the VM1 for that reason (amongst others). I get really, really clean tracks. The Phantoms, a little cheaper, but with a little less lo end and fewer directivities were great too on soft female vocals. Also, if you're concerned about boominess, try a an omni microphone. You'll be able to get closer without proximity effect. These microphones tend to sound brighter than others, but I see myself reaching for less eq...

Hope this helps,

Thomas

anonymous Mon, 03/14/2005 - 12:58

thanks guys, but that is some mighty expensive mics you're recommending. I was hoping that I would be able to get a quality mic for less money.

I've already tried to experiment with the mic position, so I think I know how that works.

What is the advantage of having a more sensitive mic? how would that be different from just turning om the preamp?

anonymous Mon, 03/14/2005 - 15:54

The Avalon is about twice the price (or more) of the Phoenix DRS-1. Since the drs-1 should be a very nice preamp, I'm pretty much decided for that one already. It is a preamp only though.

Still I believe it would be a good idea to try out some different mics as well, because I'm looking for a very different sound and I don't believe that it can be achieved by only replacing the mackie.

Markd102 Mon, 03/14/2005 - 16:06

Bjarne wrote: Still I believe it would be a good idea to try out some different mics as well, because I'm looking for a very different sound and I don't believe that it can be achieved by only replacing the mackie.

I think you'll be VERY surprised. I took my Buzz Audio pre to a mate's place to AB it against his Mackie. The difference was astounding. He hasn't recorded anything through his Mackie since.

And the Phoenix is also a very nice unit. Get that and try the NT1000 on it before you spend more on mics.