I have a very nice acoustic guitar track that I put down, but it has a small 1 or 2 second segment with some intermittent static (I think it came from the pickup jack).
I can easily re-record it, of course, but I'd really like to know how I can clean it up. What would be the technique for getting rid of static from a music track?
Thanks
Comments
Waves De-Click works ok, or just zoom in and re-draw the wave.
Waves De-Click works ok, or just zoom in and re-draw the wave.
can you post a clip?
can you post a clip?
Software is "Cubase LE 4.1.2 / Sonar 1" in OPs sig... Is there
Software is "Cubase LE 4.1.2 / Sonar 1" in OPs sig...
Is there a signal that you want to keep while the static is audible?
Even if you have a good noise reduction plug-in, it will be fast
Even if you have a good noise reduction plug-in, it will be faster to play it again. Redrawing the waveforms can be very time-consuming.
dvdhawk is right. just redo the part and save yourself time.
dvdhawk is right. just redo the part and save yourself time.
Here is a wma file mix-down of the clip: http://www.mediafire.c
Here is a wma file mix-down of the clip:
http://www.mediafire.com/?kzbfzvyyylm
P.S. In this particular case, I know it would take less time to re-do the clip. I just thought it would be an opportunity for me to ask what the options were for dealing with this type of situation. Thanks!
Static on an acoustic guitar? That's easy: buy a better guitar
Static on an acoustic guitar? That's easy: buy a better guitar. 8) But seriously, acoustic guitars shouldn't get any noticable static. Try micing it. I loathe acoustic guitar pickups. Well, I really just hate batteries, but the pickups really aren't that great on acoustic electric guitars. Even on T@ylors. Use less compression? Use a better compressor? Learn how to use compression properly? I am a bit puzzled on the whole static thing. Input jacks are cheap. Buy one. Rewire the thing while you're at it.
quesne, you got some nasty broadband static there. there is no w
quesne, you got some nasty broadband static there. there is no way to get rid of it. also, you have a gap in your audio with no signal. time to get that guitar out and start recording.
My hat is off to you for wanting to learn about the technology o
My hat is off to you for wanting to learn about the technology or tricks to deal with static, and as was mentioned, you either need good Broadband Intelligent Noise Reduction Software - or you can try to redraw the waveform. Both will sacrifice fidelity and are only useful in small doses. Usually with BINR you need a clean sample of the noise, so the software go scour matching noises out of the track. And that almost always leaves artifacts and audible holes, especially with somethings as pure as an acoustic guitar.
I agree, that particular track is probably beyond repair.
And changing the jack on an acoustic might be relatively cheap, but it isn't always easy. A good contact cleaner might be all you need.
Thanks very much for the input. I re-recorded the track, of cou
Thanks very much for the input. I re-recorded the track, of course!
I think the dead space was probably due to the amateurish copy-and-paste mock-up I was doing before I discovered the static.