Skip to main content

cold

Cold Hard Soul

Your Avatar
Submitted by Jonathan Linton on Sun, 02/02/2020 - 04:49

Hi all,

Wrote this song over the weekend and I would appreciate feedback.

Also, I would like feedback on what genre this is - I can't figure that out myself!

[MEDIA=soundcloud]jonathan-linton-3/cold-hard-soul[/MEDIA]

COLD HARD SOUL
(Words by Jonathan Linton, Music by Jonathan Linton)

Well..it's cold solder joint time again ...

Your Avatar
Submitted by Guelph_Guy on Sat, 03/26/2016 - 01:20

Okay, just a re-cap, I had picked up a used big ben .. that the narrow lock light became intermittent, it was a cold solder joint on the board .. once re-flowed good to go ...

So I'm making some changes in the home studio, I had purchased a Yamaha KX8, weighted 88 key keyboard that supported USB and midi. As I was fully midi enabled, I just plugged it in and off I went ..

Microphone left in the cold

Your Avatar
Submitted by anonymous on Sat, 01/19/2008 - 21:49

So i was parked outside today for a good 6-7 hours and I left one of my microphones (MXL V63M Condenser) in the car. It happens to be the coldest weekend all year in Chicago this week, and its below zero the whole time. So i just got home, and noticed my mic sitting in the car freezing cold. Is this going to mess up my microphone?

RODE NTK into M-Audio 1010lt?. its too hot?..its too cold?

Your Avatar
Submitted by anonymous on Sat, 08/27/2005 - 06:32

I just got this setup the other day mainly to record french horn in a mix and alone for practicing.
I guess I just assumed I would plug it in and there would be a slider on the mixer that I could control the gain with and if it was too hot I would turn it down until it is just right.