My buddy let me use his Avalon sp737 for a couple of months.
The way i have i connected is as follows...
Mic/XLR-->Avalon/XLR-->MOTU Mic/Guitar#1/XLR W/fantom power off and trimzero..
Is this correct or should i be going thru the analoge TRS Line/input 1 in rear?
I have a small home studio and I recently purchased an MOTU 828 as my recording interface. This is the USB2 version of the interface and should really be a great addition to my set up but I cannot get it to work properly.
Does anyone know of any known issues with this interface?
will i notice a big difference if i upgrade from my MOTU 828 (mk1) to an RME multiface (mk1)?
i produce electronic music and don't do much actual recording.
i can buy a used multiface for $400 however i will then need to purchase the expresscard ($600! new and i cant find it used anywhere) so the overall investment will be about a grand.
basically, i have Shure ksm27/Avalon 737sp/motu828mk2/art X4 headphone amp.Specs lp8/ppc g5 quad.osx10.4.11 buffer @ 128
yesterday i was recording and i wanted to add a effect like reverb etc but i dont want to effect the latency.
I recently purchased a MOTU 8pre to expand the number of microphone preamps on my 828 MKII so my band can record a demo with a full drumset. I'm running Cubase SX3, and I can't figure out how to set it up so that I have 10 different inputs (8 from the 8pre, plus the 2 on the MKII) recording at once in Cubase.
I am currently using SONAR 7 Producer Ed.,
and MOTU 828 mkII for audio interface.
I use SONAR for vocal recording.
My aI'm is:
Record dry signal, but give some reverb effect to singer during recording.
What's the traditional setting to achieve, without latency?
Hi, I am planning on buying a macbook pro soon, likely 17inch, upgrading to 7200 RPM, and maybe the 4 gigs of Ram option.
Eventually I'd like to be able to do some portable multitrack recording on it. I was reading up on tweaks guide and lots of other things I could find on the net. I have a question regarding the MOTU 828MKII 24/96 Audio Interface.
First of all i'd like to say hello this is the first time on the site just found it like a hour ago wish i woulda found earlier.
Hi, I'm using my MOTU 828 markII as an interface for my computer.
In my other room I have a drum set. I have a HP PreSonus which I'm trying to use for the drummer to listen to the track but I don't know how to connect it to the MOTU 828 an get sound from it.
Please help me .
In the manual for the 828 it says
"If your host audio software does not support WDM drivers,
enable wave driver compatibility in the MOTU audio WDM driver
so that all of the 828mk11's inputs and outputs show up in your software."
What it means is to enable the (MME) drivers which are less efficiant and
it even states it.
