Hi all, I am not sure if this is the right place to ask, but I want to take a shot: I have a circuit with small silicon microphone that has acoustic overload at 128db, however environment where I am going to monitor sound can get louder than that so I need to reliable lower incoming sound pressure by approximately 30db, kind of like putting protective headphones over ears when you do constructi
Looking to reduce the level of sound into a lavalier mic by physical means, NOT via an audio pad.
It's an EBay bought iPhone mic which is very sensitive, good quality but the capsule is easily overloaded. Figured that some sort of physical barrier would be best. Appreciate any ideas.
Thanks
Hi Guys, I'm new to these forums and trying to think outside the box and any suggestions would be appreciated. I own a car audio shop in Sydney Australia and compete in DB Drag Racing SPL competition. I know this is not the correct forum but your knowledge of sound pressure behavior is maybe at a higher level or different than in the car audio industry.
I've been drafted to do the sound for a few live gigs of a band I've been working with in the studio. I have nearly no experience or training with live sound.
I've got a few questions to that extent.
1. What SPL should I be aiming at? I know that 97dB is safe for 30 minutes at a time, which is the approximate legnth of a set they're doing.
Sigh.. thought I knew this:
Speaker system rated 130 dB SPL at 1 meter (Mackie SA1521).
As we move away from the speaker, SPL drops by inverse square law.
Uh... 6dB each 2x distance? or was it 3 dB POWER each 2x?
Darn! I need to know this quick. THANKS!
What's a good level for mixing that will not hurt my ears, but will not cause me to make the bass too loud? I'm making bass-heavy electronic music, but I want it to sound nice and crisp in the mid-highs.
Thanks
I'm going to be tracking some Heavy Guitars for a project I'm working on, and I want to use a condenser on the guitar cab. But I'm a little worried that this will damage my condenser Mic. I plan on using a Studio Projects C3 along with an SM57.
I was wondering if there is anyway to measure SPL so I know if it's safe to use my C3 at close range on the Guitar Cab.
Hello,
A bit of a last-minute question: we'll be recording the day after tomorrow and we were wondering about max kickdrum SPL-levels.
In other words, can a condenser mic specified at 142dB SPL max
(0.5% THD, 1kHz, 10dB pad engaged) be safely used in, or in front of a kick ?
I've read some great reviews about this piece of gear.. does any of you have an opinion on this? link:
Link removed
thanks!
How do you use this to EQ your speakers and tune your room? I don't quite understand. Thanks!
