anonymous
9 January 2006
Well I just got a firepod, and ran a question in my mined. For whatever reason I can not figure it out. So how would I gop about hooking a preamp up to the firepod. Would I got Spdif in? I mean there is no "pre" preamp insert. Everyother input would run though the firepod preamps. I think I'm just stupid. Someone please explain.
Comments
The insert point in the signal chain of the Firepod is after the
The insert point in the signal chain of the Firepod is after the preamp. Line doesn't bypass the preamp.
So, to recap, send the output of your preamp in to the insert of the Firepod. Your best bet cabling wise will be to use an insert cable (1 TRS to dual TS). Leave the send TS unconnected and plug the return TS into the output of your preamp. Then plug the TRS end into the insert. Good Luck.
Wes
Simple my friend... send the quarter inch output from your pream
Simple my friend... send the quarter inch output from your preamp, into the firepod... right into their franken-insert to which you can connect an xlr or 1/4 inch cable... and use that input on line mode on the firepod. HOORAH!