Looking for some feedback from user's using the US-428 with Athlon based DAW's with no problems. I'm looking to build a new athlon system based around the US-428 and was hoping to get some advice on motherboard selection ETC... If you can post your system spec's it would be a great help.
Thanks in Advance
JC :)
Comments
I currently run Athlon 900 628 mb ram 30gig 7200 rpm ata/100
I currently run
Athlon 900
628 mb ram
30gig 7200 rpm ata/100 --Audio
20 gig 5400 rpm - data
plextor 12 x cdrw
echo layla 20
us-428
Nuendo
I think the Us 428 is a good control surface and a great upgrade from mouse mixing... it works almost naturally with Nuendo.
As a soundcard it has 24 bit analog inputs; I have had slight latency issues with the inputs and I found the converters not to be great...
I have had know technical problems with the unit at all for the most part...
I recommend this unit as a control surface only and as a great leap from mixing from a mouse.. But after sometime you will outgrow the lack of motorized faders and the toyish frame....
I plan to upgrade my 428 to the yamaha aw4416
..
Raticus
Athlon 1Ghz CPU ASUS A7V133 2 40Gb IBM 60GXP Drives (ATA100)
Athlon 1Ghz CPU
ASUS A7V133
2 40Gb IBM 60GXP Drives (ATA100)
1 Western Digital Caviar Drive (ATA100)
Mitsumi CDR
512 mb RAM
Nuendo
Tascam US-428
Plus Outboard Analog Gear.
No Problems at all. I'm about to purchase two RME mutifaces for more i/o and better converters. I track on analog gear and use nuendo for multitracking and native effects and the US-428 as a controller and a/d conveter.