Skip to main content

Well, I've had it with digital pianos and Gigapiano, I just can't get a satisfying sound and realistic dynamics from anything I've tried, so I am buying an upright to use in my recordings, but I have no idea how to place the mikes, or what type of mikes (low budget) I need to do this. Any help will be greatly appreciated !

Comments

lorenzo gerace Wed, 03/26/2003 - 05:37

Hi

Usually the best way to record an upright piano is to put the mikes over the open lid, one for the higher side, one for the low keys, spreading them apart as needed to get the correct stero image without phase issues and starting with a distance of 10" from the edge, going away for a more overall sound, as the closer approach will result in a very defined sound with lots of hammers click; I never tried to use stero techniques on an upright piano, but who knows, it could work OK, just try it.

For mics I'd go with a pair of large dia condensers like Neumann U87 or TLM103 (expensive) to AKG 414 B-ULS (middle of the way) to budget mics like Audio Technica 3035 or Rode NT1000 (which IMO are still very good sounding).

As good as condenser mics can sound on piano I heard one of the best upright piano recordings made with a pair of Sennheiser MD421 (dynamic), for a pop context.

Hope this helps

L.G.

anonymous Thu, 03/27/2003 - 16:50

You mentioned low bedget so I thought I'd chime in...

I've Use a pair of Marshall MXL 603s on upright piano before with good success.

Only problem was th upright was a spinnet which is actually have the height of an upright and sounds like poo. They are very hard to tune and keep in tune.

Anyway, you should be able to get a pair of 603s (the 's' is in the model name and does not denote plural) with shockmounts and a carrying case for about $200.

I want to second Gerax's recommendations on mic technique. The first time I mic'd an upright over the open lid I mic'd too close and there was all sorts of clicks and squeaks!

Peace,
Brad

Peace,
Brad

Markd102 Fri, 03/28/2003 - 20:53

Originally posted by Azure Crystal:

and one on the soundboard (the back).

Good point, I was thinking that you prolly want to get those warm overtones coming from there... How do I get away from phasing ? Can you elaborate a bit ? Just experiment with mic placement. Obviously you don't want your mics pointing at each other, so start with your rear mic angled towards the floor, then move it around to find a sweet spot. Moving you overheads up and down can help too.

On removing panels, I generally try not to. the piano's overall acoustic sound comes from having all the panels in place. All wood in/on a piano is there to resonate and give it tone. That said, some old pianos can benefit from the removal of a couple of panels. Experimentation is the name of the game.

Note that these are my experiences only. I ain't no eggspert. ;)

:c:

Mark

anonymous Wed, 04/23/2003 - 06:53

I realize that I'm a little late on this, but I'll offer up my $0.02:

I recently did quite a bit of live jazz orchestra recording which included an old upright piano. I found that the best sound came from close-micing with an Audio Technica Pro37R on the soundboard.

Place the mic pretty close in and start with it pointed in the area where the two sets of strings intersect then move it around a bit to get the tone you're after.

I tried inside the lid and also down in front of the strings and could not get a good sound from either position. Actually, this particular piano didn't really have a lid, the whole front piece - from the music stand upward - lifted up from a hinge on the top rear. So, the mic was actually kind of in front of the hammers and not above them.

At any rate - try micing the soundboard. I think you'll find you like what you hear. Also, the reason I used the AT Pro37R is because 1)it's inexpensive (budget reasons), 2)it sounds great, and 3)being a live situation, I needed to keep the bleed to a minimum (it's a small diaphragm condensor).

Good luck.