OK, I already posted this in the sticky thread. BUT THIS IS SO BIG THE WHOLE WORLD HAS TO KNOW ABOUT IT!

And it's FREEWARE!

;)

I quote the developer for the instructions:

Left click in big box and drag left/right to set gain from 0db - 16db
Right click in big box and drag left/right to set freely -96db - 16db

Same can be done in the Gain box.

Left click in Output box and drag left/right to set
the output ceiling (-60 - 0db )

Right click in output box to reset (0db)

DULL/SHARP left click and drag left/right to set
peak shape. Too sharp produces clicks and pops...

Left klick in Algorithm Box to toggle FULL/SMOOTH algo.

Left click EQ to open/close EQ section..
Right click to turn off/on Body/EQ.

Left click and drag left/right on body,bass,mid,hi
sliders.

right click on sliders to reset.

Left click and drag left/right in Freq boxes to
set freq:

Bass = 80-500hz (breakpoint)
Mid = 500-3000hz (center pos)
hi = 3000-20000hz (hi end enhancer)

Body will beef the input signal
Bass will beef the low end.
Mid will raise the gain of mid range.
Hi will enhance hi end.

Experiment! (I do. )