recording bass

I have used a lot different mics. I like the RE20, AKG D112, Rode NT2. I recently got some earthworks QTC 50's I am egar to see what they do on a bass amp.

1st, it has to be a damn good bass amp. Most bass amps are fine for live, but don't really do a good job in the studio.

2nd - no matter what you mic it with, take a DI as well.

3rd- I've had good results with Senn 441 which you can sometimes find used for about your budget.

Also an Audio Technica ATM25 which is also in your price range

"best Bass amp mic set up for under $300?". Is this for recording or live performance?



For strictly recording purposes, I wouldn't bother with the amplifier and cabinet. I would use a quality device such as the Bass POD or a SansAmp Bass direct box (DI).



Recently I mixed a rock-and-roll band's CD in somebody else's studio and had the opportunity to utilize an Empirical Labs Distressor, which I elected to use on the DI bass track. I was blown away by how great a sound I got from the bass with that Distressor! It may very well become my next purchase?



Distressor free

Ms. Remy Ann David

Beyer M88 8)

Again, for those paying attention. There is no best. On the less expensive side, I like the MD421 or AT4047 although you will likely need to buy used to fit your budget.



Remy, where have you been hiding. The Distressor has become an industry standard now for several years. Capture your face expression the first time you use one or a pair on drums or on a room mic...

An easy set-up "on the cheap" is to run the bass into an Ampeg B15 AND a 60s Fender Princeton, mic both amps with EV RE11s and mix to taste. The Princeton adds a lot of clarity and definition to the otherwise fantastic bass tones from the B15.



This setup could be recorded with SM57s or 58s just as easily, and still sound fine.

Really...? I have a tan Tolex '63 Princeton. If somebody even thought about running a bass through its' speaker, I'd shoot to kill !

REMY,



So you ran the bass into the DI then into the Distressor? Sounds like a cool idea. I have a distressor and will be buying a sans amp bass driver soon. Thanks for the info.



Justin

moonbaby wrote: Really...? I have a tan Tolex '63 Princeton. If somebody even thought about running a bass through its' speaker, I'd shoot to kill !

I'm with you on that. The idea of putting a bass through one of those sends chills up my spine.

The best sounding bass i have ever recorded has been DI into an avalon wile compressing it. it always works real well for me. i have yet to record a bass amp, but i look forward to doing so with a nice amp.

Small guitar amp and bass at a LOW VOLUME.



This is the key. The detail will be evident the moment you hear it. The Princeton's ten is very quick and will not over-excurse creating speaker flap and buzz.



Again, LOW volume.

moonbaby wrote: Really...? I have a tan Tolex '63 Princeton. If somebody even thought about running a bass through its' speaker, I'd shoot to kill !

Yes, lower volume IS the key. I like it at just under half (say, 3.5-4), so it's loud enough to light the tubes up a bit, but not push the speaker too hard. Due to the open back cabinet, much of the low end is canceled out anyway (hence the clarity). And since this amp does not break up very much at higher volumes, it does no good to crank it.



I have used my BF '66 Princeton since it was new for practicing guitar and bass! Never had any problems... It was also my first PA!



The Princeton is my favorite "clean" amp to record guitar, bass, most keyboards and electric pianos, and even some vocals through. Mine has the original ceramic Jensen speaker (gold/brown Fender label). Sounds great! :D

try an Audix D6. It has a nice meaty low end punch... blend with a DI.