Skip to main content

Hello,

I'm using Lexicon PCM 91 and would like to create own presets from the existing (factory pre-built) ones. I used preset "M HALL*STAGE" in "PRO MODE". After editing the preset I tried to save it under REGISTER BANKS. The customized preset was saved, but some of the settings were signed with dot (.) and - consequently! - not saved. Those settings are the following: LOW RT, PRE DELAY, MSTR DLY, HIGH CUT.
After restarting PCM 91 , the named settings were restored with previous, not the modified values.
I also tried to save the modified preset on different locations, but the results were the same.

Any suggestions for the problem described?

Thanx in advance,
Tadej

Comments

pr0gr4m Thu, 01/12/2006 - 10:17

1.5 Mem Protect
The PCM 91 provides a memory protection feature to prevent
accidental overwriting of your stored effects. When this control is
set to On, pressing the front panel Store button will cause an error
message to be displayed. The PCM 91 is shipped with the Memory
Protection function turned Off.

Make sure this is turned off.