Where is the fuse in a Sterling PSM1 power supply
I have it opened up and nobody can seem to locate the fuse.
active monitor fuse problems
Hi again.. Recently there was a problem with the electricity lines outside my house sparks flying off it which then blew a fuse at the outside pole cutting of power to my house.Ive got a small recording studio away from it and when the power came back on I checked to see if my equipment was ok it was except my active monitors which didn't come on.
- Read more about active monitor fuse problems
- 10 comments
- Log in or register to post comments
Blow a fuse?
Alright, so soon my and my buddies will be jamming out, and recording a little bit of it (more jamming than recording) and I'm bringing over my audio equipment, plus all of our amps. We will be in a rather small room (size of a bedroom roughly, maybe smaller. As the room is at my buddies house so I do not have dimentions) and have a bit of equipment:
- Read more about Blow a fuse?
- 9 comments
- Log in or register to post comments
Fuse conFUSEing
i blew a 250V BUS MDL 1/4 fuse in a mic preamp. i am in Burundi (220v land) and can only find a fuse that says it is:
BS 2950A 15A
the different ratings systems confuse me. why no amp rating on N.A fuse? why no V rating on British Standard fuse?
- Read more about Fuse conFUSEing
- 5 comments
- Log in or register to post comments
hello this is my first post - every mix I do gets confused
hello,
I try to make music with synths and romplers but everything gets very confused. I try to raise the volume to distinguish sounds but everything gets even more mangled.
What should I do to avoid this?
Thanks!
speaker fuse protection
Someone suggested I put fuses in the speaker cable to avoid blowing the tweeters, especiallly as I am new to DAW. I am using NS-10Ms with an 80 watt Rotel stereo amp, and Mbox2. Does anyone know if this is necessary, and if so, what rating fuses to use?
- Read more about speaker fuse protection
- 5 comments
- Log in or register to post comments
MOTU 828 fuse
Hello guys..
I need some info regarding the internal fuse of the MOTU 828..
- Read more about MOTU 828 fuse
- Log in or register to post comments
1176 internal fuse rating
Just got an 1176 off ebay. The internal fuse was not in there nor the fuse holder. Managed to fit a newer internal fuse holder inside the casing but was wondering what fuse should I put in?
I fitted a 1 amp one and the unit works fine but is this the right rating to protect it?
Any comments much appreciated.
- Read more about 1176 internal fuse rating
- 5 comments
- Log in or register to post comments
weird fuse problem
this question is for people with some electrical knowldge. I have a Marshall JCM800, and the fuse broke down, so I bouth a pack of 3 fuses, each is 1amp, like the Marshall requires. I replaced the bad fuse, and the new one broke down five minutes later, playing at mid level, when I replaced it, i broke again, and again... I need help, why is this happening?
- Read more about weird fuse problem
- 2 comments
- Log in or register to post comments