What's up everyone! This is my first time posting here.

I have a PC. I use the M-audio Firewire 410 sound card, my Behringer Eurorack UB-1622fx pro mixer and my Sony A/V receiver and this is how I had it set up.

Sony A/V reciever's CD input TO Behringer Tape output

M-audio Firewire 410 Line output 1/2 TO Behringer Channel 5/6 input.(Stereo)

I cannon get Cubase 5 to recognize my Alesis Multimix 8 USB. (Please note that it is not the USB 2.0 model.)

I have tried visiting the Alesis website to download ASIO drivers, however there are none available for this board, as it is a plug n play device. The board included a copy of Cubase 4 le, so I am assuming that it SHOULD be compatible with Cubase 5.

Hello. I am recording a singer who has a very loud upper range, and often clips out when recording. However, when she drops down in her lower range, she is almost inaudible. The signal chain runs as follows:

Cardoid condenser mic
/
PreSonus TubePre
/
Behringer Compressor
/
Alesis Multimix
/
PC via usb

Ok so I connect my bass to a direct box and next to a preamp that goes to an interface.
I notice a kinda click sound every now and then so I think well maibe a bad cable. I change the bass cable dosnt seem to solve the problem.

I've had a MOTU 8pre for almost 2 years. It worked great for quite a while.

This fall it began to disrupt my whole computer. I run XP Professional on an Intel board, Intel Quad Core processor, 8 gigs of ram. Freeze-ups of any type of program that uses audio. My DAW is Cubase SX3.

I dont know if it is to do with the zoom hd8 or the mic but when i try and record it makes a terrible howling sound - like the wind howling - then popping - my mic is a Behringer b2pro - i have bought a new lead and that worked for a while but now it just does the same with that - I'm quite new to all this equiptment and any advice would be appreciated. thanks.

Hi All...

I am going out of my mind trying to solve my Mobilepre audio problem!

My problem is that whenever I record through Cubase SX3, Ableton whatever. I can hear clicks and within a few seconds
a horrible squelching noise takes over, I have to close out the program to get rid of it. this also happens if I listen to or watch something in Windows

Well, I have a Firebox and had a small problem getting it to run as my default audio device in Vista 64. I have a dual boot PC with Vista 64 on one drive and XP 32 bit on the other. I record to Cubase SX3 on the XP drive, but figured I'd use the Firebox for sound on both channels, so I can use my monitors to listen to music, etc.

hi,
i have no sound on Cubase 3 with my fatar SL 880 no matter what i do, (monitor,record). I'm kinda newbie in midi config. so what i did was inserting a cable into 1 of two outputs from my kb and on the other side plugged into IN . I don't find my kb in midi device manager list. I own an Delta 1010 LT
suggestions pls !

I own an Alesis Multimix 16 channel firewire mixer. When i power on (No connections to computer or anything), the clip light is constantly on, and when i plugin a microphone or instrument, the sound is very quiet and distorted...on all inputs and ouputs. What is wrong, and how do i go about fixing this?